mmap与malloc

There is dynamic memory in C and this points to allocation of memory in the C programming 语言 through a set of functi*** present in the C standard library. One of these is malloc, which refers to memory allocation. In the UNIX 系统 there is mmap, which refers to a memory mapped system that comes with its own unique I/O. These two (mmap and malloc) will at face value perform the same function but further scrutiny reveals some differences. These differences, that arise from functionality, are outlined below.

差异

First off, it is important to establish whether there is any evidence indicating that there is significant stifling of the memory available. This is done through the measurement of the program’s performance against memory 管理 .

The main memory allocation interface is malloc. This is the largest in the C library. Part of the management 代码 contained in it is mmap.  When malloc is running, it gathers all available system facilities. Additional system facilities can be mobilized through the kernel, which is one of the memory management strategies that systems use to ensure that there is satisfactory memory allocation. The process is  not straightforward, though, and has been made to be complicated for the sole reason of preventing people from creating simple programs that can disorganize memory allocation and hence create 贫穷的 performance.

‘mmap’ on the other hand is a system call that takes charge and requests the kernel to find an unused and contiguous region in an application’s address that is large enough to allow for the mapping of several pages of memory. There is also the creation of virtual memory management structures which in effect cannot result in a segfault.

Malloc generally functi*** in most of the memory management process. In the event the program requires additional memory, this is borrowed from the OS. Mmap on the other hand makes use of a context switch that converts into kernel land.

Malloc is best suited for allocating memory in any application running on the system as opposed to the use of mmap. This is what is required to happen by default, other than in special cases when it may be permitted.

Mmap can be used to speed up the 响应 given by applicati***. This is however not advisable as it ends up sacrificing some bytes to pages so that the application can run **oothly. Although the data content may seem **all in the beginning, extrapolating it when numerous applicati*** want to run may in effect slow down the system even further.

After measuring performance and usage of resources, a thorough evaluation of data usage by all applicati*** running on the system should be done.  If the lifetimes of the applicati*** running can be shown it can become better.

Use of mmap for allocating memory comes with the disadvantage that the allocation and deallocation of data in chunks is expensive. This is because data is split into numerous areas, and also denies mmap from making system calls.

Mmap is advantageous over malloc because memory used up by mmap is immediately returned to the OS.   The memory used up by malloc is never returned unless there is a data segment break. This memory is specially kept to be reused.

摘要

‘malloc’ stands for main memory allocation point

A mmap system calls and requests a kernel to find unused regi*** in application addresses which can accommodate mapping of several memory pages

Mmap is not recommended for allocating memory as it splits available memory and cannot make system calls

A benefit of mmap over malloc is the availability of memory, as opposed to malloc memory, which is reused.